/*

* SendDemo.cpp

*

* Demonstrates sending IR codes in standard format with address and command

*

* This file is part of Arduino-IRremote https://github.com/Arduino-IRremote/Arduino-IRremote.

*

************************************************************************************

* MIT License

*

* Copyright (c) 2020-2023 Armin Joachimsmeyer

*

* Permission is hereby granted, free of charge, to any person obtaining a copy

* of this software and associated documentation files (the "Software"), to deal

* in the Software without restriction, including without limitation the rights

* to use, copy, modify, merge, publish, distribute, sublicense, and/or sell

* copies of the Software, and to permit persons to whom the Software is furnished

* to do so, subject to the following conditions:

*

* The above copyright notice and this permission notice shall be included in all

* copies or substantial portions of the Software.

*

* THE SOFTWARE IS PROVIDED "AS IS", WITHOUT WARRANTY OF ANY KIND, EXPRESS OR IMPLIED,

* INCLUDING BUT NOT LIMITED TO THE WARRANTIES OF MERCHANTABILITY, FITNESS FOR A

* PARTICULAR PURPOSE AND NONINFRINGEMENT. IN NO EVENT SHALL THE AUTHORS OR COPYRIGHT

* HOLDERS BE LIABLE FOR ANY CLAIM, DAMAGES OR OTHER LIABILITY, WHETHER IN AN ACTION OF

* CONTRACT, TORT OR OTHERWISE, ARISING FROM, OUT OF OR IN CONNECTION WITH THE SOFTWARE

* OR THE USE OR OTHER DEALINGS IN THE SOFTWARE.

*

************************************************************************************

*/

#include <Arduino.h>

#include "PinDefinitionsAndMore.h" // Define macros for input and output pin etc.

#if !defined(ARDUINO_ESP32C3_DEV) // This is due to a bug in RISC-V compiler, which requires unused function sections :-(.

#define DISABLE_CODE_FOR_RECEIVER // Disables static receiver code like receive timer ISR handler and static IRReceiver and irparams data. Saves 450 bytes program memory and 269 bytes RAM if receiving functions are not required.

#endif

//#define EXCLUDE_EXOTIC_PROTOCOLS // Saves around 240 bytes program memory if IrSender.write is used

//#define SEND_PWM_BY_TIMER // Disable carrier PWM generation in software and use (restricted) hardware PWM.

//#define USE_NO_SEND_PWM // Use no carrier PWM, just simulate an active low receiver signal. Overrides SEND_PWM_BY_TIMER definition

//#define USE_ACTIVE_HIGH_OUTPUT_FOR_SEND_PIN // Simulate an active high receiver signal instead of an active low signal.

//#define USE_OPEN_DRAIN_OUTPUT_FOR_SEND_PIN // Use or simulate open drain output mode at send pin. Attention, active state of open drain is LOW, so connect the send LED between positive supply and send pin!

//#define NO_LED_FEEDBACK_CODE // Saves 566 bytes program memory

//#undef IR_SEND_PIN // enable this, if you need to set send pin programmatically using uint8_t tSendPin below

#include <IRremote.hpp>

#define DELAY_AFTER_SEND 2000

#define DELAY_AFTER_LOOP 5000

void setup() {

}

/*

* Set up the data to be sent.

* For most protocols, the data is build up with a constant 8 (or 16 byte) address

* and a variable 8 bit command.

* There are exceptions like Sony and Denon, which have 5 bit address.

*/

uint16_t sAddress = 0x0102;

uint8_t sCommand = 0x34;

uint16_t s16BitCommand = 0x5634;

uint8_t sRepeats = 0;

void loop() {

}