Standalone AVR programmer

This sketch can be used to let one Arduino program a sketch or bootloader into another one, using the ISP programming pins.

This sketch is based on OptiLoader, but modified for use with Adafruit's adaloader and to be used without a serial connection. It is intended to be used with Adafruit's standalone programmer kit (a protoshield with ZIF socket, buttons, leds and a buzzer), but it should be usable with any Arduino wired up to any AVR chip (respecting the pinout, see below).

The sketch to be flashed is stored in the images.cpp file inside this sketch. By default, it contains the adaLoader bootloader, but you can replace it with your own bootloader or sketch as well. To do so, compile that sketch into a .hex file (using the Arduino IDE, you can use "Sketch" -> "Export compiled Binary" to get the compiled .hex file) and paste its contents (it's just a text file) into images.cpp (see that file for details). There you can also configure the target chip signature and fuse settings.

For more info on setting this up, see Adafruit's tutorial.

Pinout

To use this sketch, you can use the following pinout. Here, "programmer" means the Arduino running this particular sketch, "target" means the chip being programmed. For reference, this also lists pin numbers for an Arduino Uno programmer and bare atmega328p target chip, adapt these if you use a different setup.

Programmer pin	Uno pin number	Connects to
Digital pin 10	10	Target RESET (atmega328p pin 1)
MOSI	11	Target MOSI (atmega328p pin 17)
MISO	12	Target MISO (atmega328p pin 18)
SCK	13	Target SCK (atmega328p pin 19)
Digital pin 9	9	Target XTAL1 (optional, atmega328p pin 9)
Digital pin 8	8	Error LED (active high)
Analog pin 0	A0	Activity LED (active high)
Analog pin 1	A1	Button (active low, internal pullup enabled)
Analog pin 3	A1	Piezo (outputs 4kHz square wave)

Leds & buzzer

On startup, both leds blink twice and then turn off.

When the target is being programmed the activity led turns on. Once it is done, the led turns off and the piezo makes a short beep.

When an error occurs during programming or verification, the error led turns on and stays on and the the piezo makes a continuous beep.

Clock output

This sketch generates an 8Mhz clock as an extra utility. This can be used if the target chip has fuse settings that expect an external clock (or crystal, that also seems to work). If you are only configuring the fuses to use the internal oscillator, this is not needed.

Button

A single button can be connected, which can be used to start programming the next chip (including the first). Alternatively, you can send a command (uppercase 'G') through serial to start programming.

Autostart

This sketch also supports autostarting the programming when a chip is connected. This works by detecting the (internal or external) pullup on the reset line. To make sure that the pin reads LOW when nothing is connected, this needs a big pulldown on the ISP reset line (so between digital pin 10 on the programmer and GND). It should be big enough to not interfere with the target's reset pullup, so something like 1M should be ok.

To enable autostart, add the pulldown resistor and set AUTOSTART to 1 in the .ino file.

Now, when you insert a chip and the reset line is stable for a short while, the programming will automatically start. If the programmer is powered up or reset while a chip is inserted, it must be removed and re-inserted to start programming (of course, you can still use the button or serial as well).

denisn73/Standalone-Arduino-AVR-ISP-programmer

About

Resources

Stars

Watchers

Forks

Releases

Packages 0

Languages

Packages