net: hns3: Change fw error code NOT_EXEC to NOT_SUPPORTED

Yunsheng Lin · davem330 · commit 4a402f47cfce · 2019-01-23T11:13:01.000-08:00
According to firmware error code definition, the error code of 2
means NOT_SUPPORTED, this patch changes it to NOT_SUPPORTED.

Signed-off-by: Yunsheng Lin &lt;linyunsheng@huawei.com&gt;
Signed-off-by: Peng Li &lt;lipeng321@huawei.com&gt;
Signed-off-by: Huazhong Tan &lt;tanhuazhong@huawei.com&gt;
Signed-off-by: David S. Miller &lt;davem@davemloft.net&gt;
diff --git a/drivers/net/ethernet/hisilicon/hns3/hns3pf/hclge_cmd.c b/drivers/net/ethernet/hisilicon/hns3/hns3pf/hclge_cmd.c
@@ -259,6 +259,8 @@ int hclge_cmd_send(struct hclge_hw *hw, struct hclge_desc *desc, int num)
 
 			if (desc_ret == HCLGE_CMD_EXEC_SUCCESS)
 				retval = 0;
+			else if (desc_ret == HCLGE_CMD_NOT_SUPPORTED)
+				retval = -EOPNOTSUPP;
 			else
 				retval = -EIO;
 			hw->cmq.last_status = desc_ret;
diff --git a/drivers/net/ethernet/hisilicon/hns3/hns3pf/hclge_cmd.h b/drivers/net/ethernet/hisilicon/hns3/hns3pf/hclge_cmd.h
@@ -39,7 +39,7 @@ struct hclge_cmq_ring {
 enum hclge_cmd_return_status {
 	HCLGE_CMD_EXEC_SUCCESS	= 0,
 	HCLGE_CMD_NO_AUTH	= 1,
-	HCLGE_CMD_NOT_EXEC	= 2,
+	HCLGE_CMD_NOT_SUPPORTED	= 2,
 	HCLGE_CMD_QUEUE_FULL	= 3,
 };
 
