arm64: dts: clearfog-gt-8k: 1G eth PHY reset signal

baruchsiach · gclement · commit babc5544c293 · 2018-11-30T18:44:53.000+01:00
This reset signal controls the Marvell 1512 1G PHY.

Note that current implementation queries the PHY over the MDIO bus
(get_phy_device() call from of_mdiobus_register_phy()) before reset
signal deassert. If the PHY reset signal is asserted at boot time, PHY
registration fails. So current code relies on the bootloader to deassert
the reset signal.

Signed-off-by: Baruch Siach &lt;baruch@tkos.co.il&gt;
Signed-off-by: Gregory CLEMENT &lt;gregory.clement@bootlin.com&gt;
diff --git a/arch/arm64/boot/dts/marvell/armada-8040-clearfog-gt-8k.dts b/arch/arm64/boot/dts/marvell/armada-8040-clearfog-gt-8k.dts
@@ -333,6 +333,10 @@
 		 */
 		marvell,reg-init = <3 16 0 0x1017>;
 		reg = <0>;
+		pinctrl-names = "default";
+		pinctrl-0 = <&cp0_copper_eth_phy_reset>;
+		reset-gpios = <&cp1_gpio1 11 GPIO_ACTIVE_LOW>;
+		reset-assert-us = <10000>;
 	};
 
 	switch0: switch0@4 {
