clk: ti: clkctrl: Fix clkdm_name regression for TI_CLK_CLKCTRL_COMPAT

tmlind · bebarino · commit d17a718db40d · 2019-03-08T10:35:07.000-08:00
Commit a72d785 ("clk: ti: Prepare for remove of OF node name") changed the code to use kasprintf() for provider->clkdm_name but also changed the offset used later on by three. We don't need to change the offset as we already have the extra three characters in the format for kasprintf with "%pOFnxxx". This caused the clocks with TI_CLK_CLKCTRL_COMPAT to have NULL clk->clkdm_name for omap4 and 5. And null clkdm_name can cause module reset, enable, and idle to fail. The issue can also be seen also when enabling DEBUG for clkctrl.c and then we start seeing "clock: could not associate" messages for omap4 and 5 as the generated name is something like "l4_wkclkdm" instead of "l4_wkup_clkdm" that's needed. Let's fix the issue with a partial revert of commit a72d785 ("clk: ti: Prepare for remove of OF node name"). ALso note that in general code should not depend on the dts node names. And the node names should be generic types like clock-domain in this case. This could be fixed later by using separate compatible properties for the clockdomains, or by adding soc_device_match() table with reg offsets to the driver. But let's fix the regression first. Fixes: a72d785 ("clk: ti: Prepare for remove of OF node name") Cc: Tero Kristo <t-kristo@ti.com> Signed-off-by: Tony Lindgren <tony@atomide.com> Signed-off-by: Stephen Boyd <sboyd@kernel.org>
diff --git a/drivers/clk/ti/clkctrl.c b/drivers/clk/ti/clkctrl.c
@@ -530,7 +530,7 @@ static void __init _ti_omap4_clkctrl_setup(struct device_node *node)
 		 * Create default clkdm name, replace _cm from end of parent
 		 * node name with _clkdm
 		 */
-		provider->clkdm_name[strlen(provider->clkdm_name) - 5] = 0;
+		provider->clkdm_name[strlen(provider->clkdm_name) - 2] = 0;
 	} else {
 		provider->clkdm_name = kasprintf(GFP_KERNEL, "%pOFn", node);
 		if (!provider->clkdm_name) {
