PM / OPP: Update performance state when freq == old_freq

vireshk · rafaeljw · commit faef080f6db5 · 2019-03-12T09:45:56.000+01:00
At boot up, CPUFreq core performs a sanity check to see if the system is running at a frequency defined in the frequency table of the CPU. If so, we try to find a valid frequency (lowest frequency greater than the currently programmed frequency) from the table and set it. When the call reaches dev_pm_opp_set_rate(), it calls _find_freq_ceil(opp_table, &old_freq) to find the previously configured OPP and this call also updates the old_freq. This eventually sets the old_freq == freq (new target requested by cpufreq core) and we skip updating the performance state in this case. Fix this by also updating the performance state when the old_freq == freq. Fixes: ca1b5d7 ("OPP: Configure all required OPPs") Cc: v5.0 <stable@vger.kernel.org> # v5.0 Reported-by: Niklas Cassel <niklas.cassel@linaro.org> Tested-by: Jorge Ramirez-Ortiz <jorge.ramirez-ortiz@linaro.org> Signed-off-by: Viresh Kumar <viresh.kumar@linaro.org> Signed-off-by: Rafael J. Wysocki <rafael.j.wysocki@intel.com>
diff --git a/drivers/opp/core.c b/drivers/opp/core.c
@@ -760,7 +760,7 @@ int dev_pm_opp_set_rate(struct device *dev, unsigned long target_freq)
 		old_freq, freq);
 
 	/* Scaling up? Configure required OPPs before frequency */
-	if (freq > old_freq) {
+	if (freq >= old_freq) {
 		ret = _set_required_opps(dev, opp_table, opp);
 		if (ret)
 			goto put_opp;
