drm/vc4: Add FKMS as an acceptable node for dma ranges.

Under FKMS, the firmware (via FKMS) also requires the VideoCore cache
aliases for image planes, as defined by the dma-ranges under /soc.

Add rpi-firmware-kms to the list of acceptable nodes to look for
to copy dma config from.

Signed-off-by: Dave Stevenson <dave.stevenson@raspberrypi.com>

drm/vc4: Add FKMS as an acceptable node for dma ranges.

Under FKMS, the firmware (via FKMS) also requires the VideoCore cache
aliases for image planes, as defined by the dma-ranges under /soc.

Add rpi-firmware-kms to the list of acceptable nodes to look for
to copy dma config from.

Signed-off-by: Dave Stevenson <dave.stevenson@raspberrypi.com>

Merge remote-tracking branch 'stable/linux-4.19.y' into rpi-4.19.y

Merge remote-tracking branch 'stable/linux-4.19.y' into rpi-4.19.y

ARM: dts: Add sd_poll_once dtparam to bcm283x/2711

The old sdtweak overlay allowed the SD interface to be effectively
disabled unless there was a card present at boot time, but that
overlay doesn't work on bcm2711 and has largely been replaced by
a set of sd_* dtparams (which have the advantage of being board-
specific.

Add an sd_poll_once dtparam to allow the same functionality on
all Raspberry Pi boards.

See: raspberrypi#3286

Signed-off-by: Phil Elwell <phil@raspberrypi.org>

ARM: dts: Add sd_poll_once dtparam to bcm283x/2711

The old sdtweak overlay allowed the SD interface to be effectively
disabled unless there was a card present at boot time, but that
overlay doesn't work on bcm2711 and has largely been replaced by
a set of sd_* dtparams (which have the advantage of being board-
specific.

Add an sd_poll_once dtparam to allow the same functionality on
all Raspberry Pi boards.

See: raspberrypi#3286

Signed-off-by: Phil Elwell <phil@raspberrypi.org>

ARM: dts: Add sd_poll_once dtparam to bcm283x/2711

The old sdtweak overlay allowed the SD interface to be effectively
disabled unless there was a card present at boot time, but that
overlay doesn't work on bcm2711 and has largely been replaced by
a set of sd_* dtparams (which have the advantage of being board-
specific.

Add an sd_poll_once dtparam to allow the same functionality on
all Raspberry Pi boards.

See: raspberrypi#3286

Signed-off-by: Phil Elwell <phil@raspberrypi.org>

configs: Add BME680

Merge remote-tracking branch 'stable/linux-4.19.y' into rpi-4.19.y

Pre V3D fix, shuffle and squash