Hello,

Could you share a detailed example of steps you did? Unfortunately I could not reproduce it on my own, no files are listed twice with FileZilla (v3.28.0)/ftp Linux command, even the delete/rename/add operation issued on the device itself or through FTP.

Do you notice this behavior on an attached SD card too?

Please also share the FTP settings you used for connecting.

Thanks!

The ftp settings are standard, the same as I use for all Pycom board: passive, 1 session per link. Note, that this also happens with command line ftp.
It does not happen with v1.18.0 and, and I do not use an SD card. It's on internal flash. What I did not do yet is wiping out the device, re-flash and create a new file system.
The store/delete/rename cycle happens with my onboard editor (https://github.com/robert-hh/Micropython-Editor), which, when saving

• stores the saved file to a temporary name ("<old_filename>.pytemp")
• deletes the old file name
• renames the new file to the initial file name
  That mechanism is quite generic. Whenever I do that, a different file name is shown twice.
  But I can start over from a fresh device this night. Mayby teh files system is just corrupted for a different reason.

OK. I re-tested that, I took the WiPy3,

• erased it with 'make erase',
• installed a fresh copy of the development version with the erase flag set
• and then started to upload files with FireFTP.

After a upload a few file, like after the 6th file, two of the existing file names were shown twice. Listing files at the REPL prompt with uos.listdir() does not show this effect. After deleting files the duplication went away.
Edit: the same with a FiPy and using command line ftp.

Hello,

Based on your detailed steps I could reproduce the issue, thanks!
For me the problem only exists when the files are copied onto /flash directly. If they are placed in a folder (e.g.: /flash/folder) they are not listed twice, so until I fix this issue I would recommend putting your files into a folder :)

I did further testing... The problem appears, no matter of the location, when more than 8 objects (dirs+files) are located in a folder. If you copy/create the 9th file/folder then 2 items will be listed twice.

Hello,

The root cause was found and corrected, will be part of the next Development release. Thanks for reporting the problem!

Thanks. It seems anyhow to be a display only issue.