Wireless power transmission

Wireless Power transmission Bhaumik D patel Student M.E. Electrical, Ahmedabad Institute of Technology, Ahmedabad Abstract : In this paper, the main concept is power transmission without use of wires. In Electrical Power System, most of losses occurred in transmission and distribution. With the use of this concept, we can reduce these losses. This concept is known as Microwave Power transmission (MPT). Introduction: One of the major issue in power system is the losses occurs during the transmission and distribution of electrical power. As the demand increases day by day, the power generation increases and the power loss is also increased. The major amount of power loss occurs during transmission and distribution. The percentage of loss of power during transmission and distribution is approximated as 26%. The main reason for power loss during transmission and distribution is the resistance of wires used for grid. The efficiency of power transmission can be improved to certain level by using high strength composite over head conductors and underground cables that use high temperature super conductor. But, the transmission is still inefficient. According to the World Resources Institute (WRI), India’s electricity grid has the highest transmission and distribution losses in the world – a whopping 27%. Numbers published by various Indian government agencies put that number at 30%, 40% and greater than 40%. This is attributed to technical losses (grid’s inefficiencies) and theft [1]. The above discussed problem can be solved by choose an alternative option for power transmission which could provide much higher efficiency, low transmission cost and avoid power theft. Microwave Power Transmission is one of the promising technologies and may be the righteous alternative for efficient power transmission. History : Nikola Tesla he is who invented radio and shown us he is indeed the “Father of Wireless”. Nikola Tesla is the one who first conceived the idea Wireless Power Transmission and demonstrated “the transmission of electrical energy without wires" that depends upon electrical conductivity as early as 1891[2]. In 1893, Tesla demonstrated the illumination of vacuum bulbs without using wires for power transmission at the World Columbian Exposition in Chicago. The Wardenclyffe tower shown in Figure 1 was designed and constructed by Tesla mainly for wireless transmission of electrical power rather than telegraphy [3]. Fig. 1. Warden clyffe Tower, including the partially-complete cupola The world’s first fuel free airplane powered by microwave energy from ground was reported in 1987 at Canada. This system is called SHARP (Stationary High – Altitude Relay Platform) [4]. A physics research group, led by Prof. Marin Soljacic, at the Massachusetts Institute of technology (MIT) demonstrated wireless powering of a 60W light bulb with 40% efficiency at a 2m (7ft) distance using two 60cm-diameter coils in 2007 [5]. In 2008, Intel reproduced the MIT group's experiment by wirelessly powering a light bulb with 75% efficiency at a shorter distance. MIT team experimentally demonstrates wireless power transfer, potentially useful for powering laptops, cell phones without any cords. Imagine a future in which wireless power transfer is feasible: cell phones, household robots, mp3 players, laptop computers and other portable electronics capable of charging themselves without ever being plugged in, freeing us from that final, ubiquitous power wire. Some of these devices might not even need their bulky batteries to operate. A team from MIT's Department of Physics, Department of Electrical Engineering and Computer Science, and Institute for Soldier Nanotechnologies (ISN) has experimentally demonstrated an important step toward accomplishing this vision of the future. Realizing their recent theoretical prediction, they were able to light a 60W light bulb from a power source seven feet (more than two meters) away; there was no physical connection between the source and the appliance. The MIT team refers to its concept as "WiTricity" (as in wireless electricity). Sony Corporation in 2009 announced the development of a highly efficient wireless power transfer system that eliminates the use of power cables from electronic products such as television sets. Using this system, up to 60 Watts of electrical energy can be transferred over a distance of 50cm (at an efficiency of approximately 80%, approximately 60% including rectifier) [6]. This new wireless power transfer system incorporates a form of contactless electrical energy transmission technology based on magnetic resonance. With magnetic resonance, electromagnetic energy is only transferred to recipient devices that share the identical resonant frequencies as the energy source, so energy transfer efficiency is maintained, even when misalignment occurs. Furthermore, even if there are metal objects located between the transmitter and receiver, no heat induction occurs. With the growth in networked products, the number of cables used to connect these products has also increased. While data cables are rapidly being replaced with wireless communication systems such as Wi-Fi, the demand for wireless power transfer systems is also continuing to grow. Sony will proceed with its efforts to develop further technologies that meet customer needs for the wireless transfer of power across a wide range of products, distances and energy levels. Wireless Power Transmission System : William C. Brown, the pioneer in wireless power transmission technology, has designed, developed a unit and demonstrated to show how power can be transferred through free space by microwaves. The concept of Wireless Power Transmission System is explained with functional block diagram shown in Figure 2. In the transmission side, the microwave power source generates microwave power and the output power is controlled by electronic control circuits. The wave guide ferrite circulator which protects the microwave source from reflected power is connected with the microwave power source through the Coax – Waveguide Adaptor. The tuner matches the impedance between the transmitting antenna and the microwave source. The attenuated signals will be then separated based on the direction of signal propagation by Directional Coupler. The transmitting antenna radiates the power uniformly through free space to the rectenna. In the receiving side, a rectenna receives the transmitted power and converts the microwave power into DC power. The impedance matching circuit and filter is provided to setting the output impedance of a signal source equal to the rectifying circuit. The rectifying circuit consists of Schottky barrier diodes converts the received microwave power into DC power. Components of WPT System : The Primary components of Wireless Power Transmission are Microwave Generator, Transmitting antenna and Receiving antenna (Rectenna). The components are described as below. 1.Microwave Generator : The microwave transmitting devices are classified as Microwave Vacuum Tubes (magnetron, klystron, Travelling Wave Tube (TWT), and Microwave Power Module (MPM)) and Semiconductor Microwave transmitters (GaAs MESFET, GaNpHEMT, SiC MESFET, AlGaN/GaN HFET, and InGaAS). Magnetron is widely used for experimentation of WPT. The microwave transmission often uses 2.45GHz or 5.8GHz of ISM band. The other choices of frequencies are 8.5 GHz [7], 10 GHz [8] and 35 GHz [9]. The highest efficiency over 90% is achieved at 2.45 GHz among all the frequencies [9]. 2 Transmitting Antenna : The slotted wave guide antenna, microstrip patch antenna, and parabolic dish antenna are the most popular type of transmitting antenna. The slotted waveguide antenna is ideal for power transmission because of its high aperture efficiency (> 95%) and high power handling capability. 3.Rectenna: The concept, the name ‘rectenna’ and the rectenna was conceived by W.C. Brown of Raytheon Company in the early of 1960s [10]. The rectenna is a passive element consists of antenna, rectifying circuit with a low pass filter between the antenna and rectifying diode. The antenna used in rectenna may be dipole, Yagi – Uda, microstrip or parabolic dish antenna. The patch dipole antenna achieved the highest efficiency among the all. The performance of various printed rectenna is shown in Table I. Schottky barrier diodes (GaAs-W, Si, and GaAs) are usually used in the rectifying circuit due to the faster reverse recovery time and much lower forward voltage drop and good RF characteristics. The rectenna efficiency for various diodes at different frequency is shown in Table II. Advantages: Wireless Power Transmission system would completely eliminates the existing high-tension power transmission line cables, towers and sub stations between the generating station and consumers and facilitates the interconnection of electrical generation plants on a global scale. It has more freedom of choice of both receiver and transmitters. Even mobile transmitters and receivers can be chosen for the WPT system. The cost of transmission and distribution become less and the cost of electrical energy for the consumer also would be reduced. The power could be transmitted to the places where the wired transmission is not possible. Loss of transmission is negligible level in the Wireless Power Transmission; therefore, the efficiency of this method is very much higher than the wired transmission. Power is available at the rectenna as long as the WPT is operating. The power failure due to short circuit and fault on cables would never exist in the transmission and power theft would be not possible at all. Disadvantages: The Capital cost for practical implementation of WPT seems to be very high and the other disadvantage of the concept is interference of microwave with present communication systems. APPLICATIONS OF WPT : Generating power by placing satellites with giant solar arrays in Geosynchronous Earth Orbit and transmitting the power as microwaves to the earth known as Solar Power Satellites (SPS) is the largest application of WPT. Another application of WPT is moving targets such as fuel free airplanes, fuel free electric vehicles, moving robots and fuel free rockets. The other applications of WPT are Ubiquitous Power Source (or) Wireless Power Source, Wireless sensors and RF Power Adaptive Rectifying Circuits (PARC). CONCLUSION: The concept of Microwave Power transmission (MPT) and Wireless Power Transmission system is presented. The technological developments in Wireless Power Transmission (WPT), the advantages, disadvantages, biological impacts and applications of WPT are also discussed. This concept offers greater possibilities for transmitting power with negligible losses and ease of transmission than any invention or discovery heretofore made. Dr. Neville of NASA states “You don’t need cables, pipes, or copper wires to receive power. We can send it to you like a cell phone call – where you want it, when you want it, in real time”. We can expect with certitude that in next few years’ wonders will be wrought by its applications if all the conditions are favourable. REFERENCES: [1]http://cleantechindia.wordpress.com/2008/07/16/indiasindias electricitytransmission-and-distribution-losses/ [2] Nikola Tesla, My Inventions, Ben Johnston, Ed., Austin, Hart Brothers, p. 91,1982. [3] Nikola Tesla, “The Transmission of Electrical Energy Without Wires as a Means for Furthering Peace,” Electrical World and Engineer. Jan. 7, p. 21, 1905. [4] J.J. Schelesak, A. Alden and T. Ohno, A microwave powered high altitude platform, IEEE MTT-S Int. Symp. Digest, pp - 283- 286, 1988. [5] "Goodbye wires…". MIT News. 2007-06-07. http://web.mit.edu/newsoffice/2007/wireless-0607.html. [6] http://en.wikipedia.org/wiki/Sony [7] L.W. Epp, A.R. Khan, H.K. Smith, and R.P. Smith, “A compact dual-polarized 8.51-GHz rectenna for high-voltage (50 V) actuator applications,” IEEE Trans. Microwave Theory Tech., vol. 48, pp. 111-120, 2000. [8] T-WYoo and K. Chang, “Theoretical and experimental development of 10 and 35 GHz rectennas,” IEEE Trans. Microwave Theory Tech., vol. 40, pp. 1259-1266, 1992. [9] P. Koert and J.T. Cha, “35 GHz rectenna development,” in Proc. 1st Annu. Wireless Power , San Antonio, TX, 1993, pp. 457-466. [10] Brown, W.C, “The History of the Development of the Rectenna” Proc. Of SPS microwave systems workshop, pp.271- 280, Jan 1980.